NOTICIAS

Noticias industria

Noticias compañía

This is then usually followed by 4-6 steps of resin bonded diamonds and then the application of a sealer

This is then usually followed by 4-6 steps of resin bonded diamonds and then the application of a sealer

Polished concrete is achieved through applying a series of mechanical grinding and honing steps using equipment, chemical hardeners and sealers to create a surface that is aesthetically pleasing

17

2022

/

05

The wear mechanisms of diamond tools are as follows: friction wear

The wear mechanisms of diamond tools are as follows: friction wear

The wear mechanisms of diamond tools are as follows: friction wear, grain breakage, bond breakage, abrasion wear, surface fatigue and impact, friction wear makes grain blunt and smooth, bond breakage makes grain fall off, the abrasive wear reduces the strength of the BINDER and promotes the abscission of abrasive grains. The wear mechanism is different in different machining processes.

17

2022

/

05

The wear of diamond tools consists of three stages: the initial rapid wear stage (also called the transition stage) , the stable wear stage with the wear rate about constant and the accelerated wear stage

The wear of diamond tools consists of three stages: the initial rapid wear stage (also called the transition stage) , the stable wear stage with the wear rate about constant and the accelerated wear stage

So far, a lot of research has been done on the sawing mechanism of hard and brittle materials such as stone with diamond tools and the wear mechanism of diamond tools. However, due to the complexity of the sawing process

17

2022

/

05

The stable wear stage with the wear rate about constant

The stable wear stage with the wear rate about constant

Our technical team is dedicated to the development of diamond tools with different properties to meet theexpectations and requirements of worldwide customers.

17

2022

/

05

Although the application scope and machining

Although the application scope and machining

Although the application scope and machining characteristics of these tools are different, their wear mechanisms are basically the same. Because the wear of diamond tools has a great influence on the machining quality and process of the workpiece

17

2022

/

05

5 Most common grinding and polishing mistakes you should avoid

5 Most common grinding and polishing mistakes you should avoid

Make sure you inspect the floors for anything ‘above grade’ before your grinding process. You must either cut off, hand grind to level, or smack with a hammer to knock below grade. If you do not do it, you will most likely knock your diamond segment off, and do a lot of damage to your machine. Once you’ve eliminated the above grade issues, it will make it much easier for you to achieve the result you expected.

17

2022

/

05

< 1 >